http://www.cardealercheck.com/forum en Mon, 23 Nov 2009 19:43:23 GMT vBulletin 60 http://www.cardealercheck.com/forum/images/misc/rss.jpg http://www.cardealercheck.com/forum http://www.cardealercheck.com/forum/thread145631.html Tue, 17 Nov 2009 03:47:54 GMT does anyone know what kind of a falure i would have if the soleniods went bad. my transmission will enguage but it feels like the brakes are on. you can floor the pedel and it will just sit there locked. do you think this is an electrical issue or a much bigger internal issue. how do i tell. thank you for your help does anyone know what kind of a falure i would have if the soleniods went bad. my transmission will enguage but it feels like the brakes are on. you can floor the pedel and it will just sit there locked. do you think this is an electrical issue or a much bigger internal issue. how do i tell. thank you for your help ]]> Chrysler Lee http://www.cardealercheck.com/forum/thread145631.html http://www.cardealercheck.com/forum/thread145572.html Mon, 16 Nov 2009 23:03:33 GMT i have a 98 sebring and was changing the thermostat and the water outlet housing gasket , but when i went to take the bolts out of the housing they snapped. i used a drill and tap and was going to put a bigger bolt in the hole but i found out i drilled the hole crooked. i need a new housing on the bottom and didnt know if they sold this or if it was part of the head or just bolted on? please someone help. again its not the actual thermastat housing its the water housing ( the part the housing bolts to). i have a 98 sebring and was changing the thermostat and the water outlet housing gasket , but when i went to take the bolts out of the housing they snapped. i used a drill and tap and was going to put a bigger bolt in the hole but i found out i drilled the hole crooked. i need a new housing on the bottom and didnt know if they sold this or if it was part of the head or just bolted on? please someone help. again its not the actual thermastat housing its the water housing ( the part the housing bolts to). ]]> Chrysler bushdoggs http://www.cardealercheck.com/forum/thread145572.html http://www.cardealercheck.com/forum/thread145515.html Mon, 16 Nov 2009 17:18:19 GMT I should really say khloe & lemar odom.. Anyway- are they still together?
I did click category as celebrities but obviously it didn work.. Sorry :S ]]> Chrysler Callie Rose. http://www.cardealercheck.com/forum/thread145515.html http://www.cardealercheck.com/forum/thread145496.html Mon, 16 Nov 2009 14:40:52 GMT Yeah Chrysler's website has all the info. but I live in China and I thought the options would vary by the coming of the new 300C! Thanks Mack! ]]> Chrysler speedo http://www.cardealercheck.com/forum/thread145496.html http://www.cardealercheck.com/forum/thread145430.html Mon, 16 Nov 2009 02:47:30 GMT Try a junkyard. You may have to go in and pull one off yourself. Try a junkyard. You may have to go in and pull one off yourself. ]]> Chrysler thebrock1584 http://www.cardealercheck.com/forum/thread145430.html http://www.cardealercheck.com/forum/thread145419.html Mon, 16 Nov 2009 02:05:47 GMT My front windshield water spryer does not work but the back windshield water spryer works . where could the problem be ? is their two pump for both ? and where is the front pump. or where do i start? My front windshield water spryer does not work but the back windshield water spryer works .
where could the problem be ? is their two pump for both ? and where is the front pump. or where do i start? ]]> Chrysler fsrrii http://www.cardealercheck.com/forum/thread145419.html http://www.cardealercheck.com/forum/thread145373.html Sun, 15 Nov 2009 23:32:51 GMT action can i take against the dealer? I bought the car cash as is no warranties but it hasn't even been 90 days yet ]]> Chrysler meisha http://www.cardealercheck.com/forum/thread145373.html http://www.cardealercheck.com/forum/thread145370.html Sun, 15 Nov 2009 23:23:23 GMT I left my car in the garage for two days with the key in the ignition but not turned at all. When I went to turn the car on it started for a few seconds and then died. We attempted to jump start the car but eventually the motor wouldn't even turn over and all electronic systems shut down. I replaced the battery and then went to start the car. All of the electronics are working again but I have a blinking red light now below the fuel gauge and a (electric volt) symbol lit up on the dash. I just would like to know what I need to do in order to get the car started again. It is parked in the garage front end in and all of the fuses are fine. PLEASE HELP! This car has been nothing but trouble!! ]]> Chrysler Graham http://www.cardealercheck.com/forum/thread145370.html http://www.cardealercheck.com/forum/thread145369.html Sun, 15 Nov 2009 23:23:22 GMT I left my car in the garage for two days with the key in the ignition but not turned at all. When I went to turn the car on it started for a few seconds and then died. We attempted to jump start the car but eventually the motor wouldn't even turn over and all electronic systems shut down. I replaced the battery and then went to start the car. All of the electronics are working again but I have a blinking red light now below the fuel gauge and a (electric volt) symbol lit up on the dash. I just would like to know what I need to do in order to get the car started again. It is parked in the garage front end in and all of the fuses are fine. PLEASE HELP! This car has been nothing but trouble!! ]]> Chrysler Graham http://www.cardealercheck.com/forum/thread145369.html http://www.cardealercheck.com/forum/thread145344.html Sun, 15 Nov 2009 20:09:47 GMT will not start? does any both no how to reset the computers or if its possble will not start? does any both no how to reset the computers or if its possble ]]> Chrysler Ray http://www.cardealercheck.com/forum/thread145344.html http://www.cardealercheck.com/forum/thread145328.html Sun, 15 Nov 2009 17:48:42 GMT they where all in the same type on car and going the sames speed at 70 mph. they where all in the same type on car and going the sames speed at 70 mph. ]]> Chrysler Morgan http://www.cardealercheck.com/forum/thread145328.html http://www.cardealercheck.com/forum/thread145327.html Sun, 15 Nov 2009 17:48:42 GMT they where all in the same type on car and going the sames speed at 70 mph. they where all in the same type on car and going the sames speed at 70 mph. ]]> Chrysler Morgan http://www.cardealercheck.com/forum/thread145327.html http://www.cardealercheck.com/forum/thread145306.html Sun, 15 Nov 2009 14:46:48 GMT when you turn the key on everthing comes on, you hear the fuel pump but the motor will turn over when you turn the key on everthing comes on, you hear the fuel pump but the motor will turn over ]]> Chrysler Ray http://www.cardealercheck.com/forum/thread145306.html http://www.cardealercheck.com/forum/thread145284.html Sun, 15 Nov 2009 08:26:32 GMT About a month ago my car wouldn't start. No clicking, nothing. I took it into the shop and they said that all they could find was a blown fuse - and it fixed the problem...but they don't know what caused it and if it happens again, then more tests would have to be run. A few days ago, same symptom - car wouldn't start. Got it towed to a different shop bc it was the closest to my place. I told them about the situation and they took a look at it. They said the same thing. Fuse blew. But they don;t know what is causing it. They told me that the recommend taking it to th e dealer because they can't go deeper into what is causing the issue. So now it is a few days later - and it blew again.....what should I do? taking it into the dealer, its 104 dollars for diagnostic. I am so broke right now. Ive put so much money into this car. Should I just sell it? or trade it in?? ]]> Chrysler ocdformusic http://www.cardealercheck.com/forum/thread145284.html http://www.cardealercheck.com/forum/thread145263.html Sun, 15 Nov 2009 03:56:29 GMT was told a while back that the catalytic con was bad then the other day was going about 10mph and there was a noise under the hood and the car died and wouldnt restart my friend unhooked the exaust system to see if the cat con was the problem and it didnt start how do i know if its the timing chain i can get the kit for 170 and the gasket kit for 80 should i try it. my friend said it must be the timing chain but could find out that there is a valve bent when he digs into it also said he might need special tools to fix trying to figure out the best way to adress this without getting a different engine. was told a while back that the catalytic con was bad then the other day was going about 10mph and there was a noise under the hood and the car died and wouldnt restart my friend unhooked the exaust system to see if the cat con was the problem and it didnt start how do i know if its the timing chain i can get the kit for 170 and the gasket kit for 80 should i try it.
my friend said it must be the timing chain but could find out that there is a valve bent when he digs into it also said he might need special tools to fix trying to figure out the best way to adress this without getting a different engine. ]]> Chrysler Jeremy http://www.cardealercheck.com/forum/thread145263.html